AUTOMATIC DRYER INSTALLATION INSTRUCTIONS The installation, including a proper exhaust system, is the responsibility of the owner. LEAVE THESE INSTRUCTIONS Printed in U.S.A.
Read this before you start... Tools needed for ITEMS PROVIDED installation ®®o gQ • Teflon tape or pipe joint compound (gas only) • Cutting knife • Pipe wrench • Nut drivers • Level (gas only) • Screw driver (standard) ® %d\@ @ Electric Dryer Only Gas Dryer Only • Duct tape • Crescent wrench Proper installation is the responsibility of the owner. HOWEVER, SERVICE CALLS PERFORMED CONNECTION ARE THE RESPONSIBILITY Make sure you have everything 1. GROUNDED 2.
Exhaust If exhaust ductwork must run through an unheated area, the duct should be insulated and slope slightly down towards the exhaust hood to reduce conden- Hood Type Number of 90° Turns sation and lint build-up. If an existing Maximum length of 4-inch diameter rigid metal duct 0 65 ft. 59 ft. 1 2 3 4 54 44 36 28 48 38 30 22 ft. ft. ft. ft. ft. ft. ft. ft. 0 1 2 36 ft. 32 ft. 28 ft. 28 ft. 24 ft. 20 ft. 3 4 25 ft. 23 ft. 17ft. 15ft.
GAS REQUIREMENTS Use only Natural or LP (liquid propane) THE INSTALLATION MUST CONFORM If a separate ground is required by local codes, a grounding kit (Part No. 12001875) is available. It contains ground wire, clamp, ground screw and washer. Connect ground wire to back of unit with the cabinet ground screw and washer. Secure other end of ground wire to a suitable external ground connection. The wire may be secured with the clamp to a grounded COLD metal water pipe. gases.
INS TALLA TION Parts and literature are packaged inside of dryer drum. To Install... • [-_WARNING I Move dryer to an appropriate location for installation. Consider installing the dryer before the washer in side-by-side installations, to allow access to gas, electrical and exhaust connections. • Improper connection of the equipment-grc in doubt as to whether the appliance is pr outlet installed by a qualified electrician. • To prevent unnecessary risk of fire, electri ANSI/NFPA, No.
unding conductor )perly grounded. can result in a risk of electrical shock. Check with a qualified electrician or serviceman if you are Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper cat shock or personal injury, all wiring and grounding must be done in accordance with the National .S.) or the Canadian Electrical code CSA C22.1 - Latest Revision and local codes and ordinances. e appliance owner to provide adequate electrical services for this appliance.
9. At this time, make sure all gas, exhaust and HOUSEHOLD electrical connections are complete. Plug dryer in, and check operation by using the check list below. 1 0, (GAS MODELS INSTALLATION • Vent hood - 4" (10.16cm) ONLY) The burner may not ignite initially due to air in the gas line. Allowing the dryer to operate on a heat setting will purge the line. If the gas does not ignite within five minutes, turn the dryer off and wait 5 minutes. Be sure the gas supply to the dryer has been turned on.