Installation Instruction
14. Remove console mounting bracket by removing two (2)
screws securing bracket to cabinet left side panels, two (2)
screws from right side panel and one (1) screw from central
control bracket. Slightly lift assembly and remove from dryer.
See Figure 12A and 12B.
— 3 —
(continued)
W10337809C
15. Remove bulkhead assembly by first removing four (4) screws
securing the bulkhead assembly to cabinet. Slightly lift up on
bulkhead assembly and at the same time pulling away from
drum working rollers off drum. See Figure 13.
NOTE: During removal of bulkhead, take special notice of the
lower protective shield to assure proper placement during reas-
sembly.
figure 12A
figure 13
figure 14
16. Swing bulkhead assembly to side and remove two (2) harness
clips by pinching ends with pliers to disconnect harness from
bulkhead. See Figure 14.
figure 12b