Installation manual

3-3 Oil Pressure Line Installation
1. Remove the factory oil pressure switch at the
left side of the rear rotor housing and install the
Oil pressure line using the provided 3 way
fitting, and straight fitting. Route the line to the
right side of the engine (over the transmission)
to connect to the turbo in the later step.
* Apply Teflon tape on the PT thread in and
to not over tighten the fitting.
* Wrap the oil pressure line with the
provided wire loom.
3-4 Turbocharger Install
1. Remove the e-clip and two bolts and remove
the actuator off from the turbocharger.
(Parts Used #1)
2. Install the provided oil pressure fitting with
copper washer and oil return gasket with one
mounting bolt as shown.
(Parts Used #22, 26, 48, 63)
3. Install the provided stud bolts to the manifold
and turbine as shown.
(Parts Used #2, 66)
4. Place the turbocharger up by the engine, and
while holding the turbo to the side, install the
exhaust manifold to the engine.
*Use factory gasket