User guide

Installation of MBRP Inc. Performance Exhaust:
Figure 6
Figure 7
Figure 8
Figure 9
1. Loosely attach the extension pipe at the flange
using the hardware provided and slide hanger into
rubber insulator located on the frame. Refer to
figures 6 & 7.
2. Slide a band clamp over the Extension Pipe and
install muffler onto the Extension Pipe. Refer to
figure 8. Refer to illustration on page 1 for the flow
direction of the muffler.
3. Slide a band clamp over the outlet side of the
Muffler. Now feed the Over Axle Pipe over the axle
and loosely attach it to the muffler. Install the tail
pipe hangers into the factory rubber insulator
located directly above the hangers. Refer to figure 9.
4. Slide a band clamp over the Tail Pipe and install
onto the Over Axle Pipe. Now slide hanger into
rubber insulator located on the frame.
Refer to figure 10
5. Align the exhaust as required and starting at the
front of the exhaust, tighten all clamps and
connections.
6. Check along the whole length of the exhaust
system to ensure that there is adequate clearance
around the spare tire, fuel and brake lines or any
wiring. If any interference is detected relocate or
adjust.
Congratulations! You are ready to begin enjoying the
improved performance and driving experience of
your MBRP Inc. Performance Exhaust system. We
hope you enjoy your purchase
Page 3 of 3
S5034 12/07
Figure 10