Instruction Manual

S5402 © 12/12 PAGE 4 OF 4
6. Slide two 2 ½” Band Clamps onto the Muffler install the Driver Side
Over Axle Pipe. Attach the hanger to the existing rubber insulator. Install
the Passenger Side Over Axle Pipe to the Muffler. Leave connections
loose enough for some adjustment. Refer to Figure 11.
7. Attach the Driver Side Tail Pipe to the Driver Side Over Axle Pipe
using a 2.5” Band Clamp. Refer to Figure 12.
8. Attach the Driver Side Tail Pipe to the frame using the Hanger
Assembly and the hardware provided. Refer to Figure 13.
9. Attach the Passenger Side Tail Pipe to the Passenger Side Over
Axle Pipe using a 2.5” Band Clamp. Install the hanger into the rearmost
rubber insulator and reattach to the frame. Refer to Figure 14.
10. Install and adjust the Exhaust Tips to suit. Using a 17mm wrench
tighten the lock bolt located on each Exhaust Tip.
11. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
13. Carefully position the ABS line to provide clearance to the exhaust.
Refer to Figure 15. Check along the whole length of the exhaust system
to ensure that there is adequate clearance around the spare tire, fuel and
brake lines or any wiring. If any interference is detected relocate or
adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15