Removal of Stock System: 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. 2. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from the rubber hangers and remove the system from under the truck. 3. Using a 15mm socket wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe. Installation of MBRP Inc. “Smokers TM”: 1.
6. Loosely attach the Stack Mounting Bracket to the front of the truck bed using the 3/8” hardware supplied. Set the Stack up in the bed and loosely attach it to the Stack Mounting Bracket. Make sure the Stack is vertical and in the desired position. Refer to Figure 3. Figure3 7. Confirm the base of the Stack is resting in the same position as in Step 4. Re-trace and center punch if needed. This is where the 18” Extension Pipe will pass through the floor. Remove the Stack from the bed of the truck.
10. Slide the Bed Mounting Bracket onto the 18” Extension Pipe. Install the assembly on the outlet of the 20” Elbow with the required Clamp. Reinstall the Stack by sliding the inlet over the 18” Extension Pipe and then securing the Stack to the Stack Mounting Bracket with the Clamps supplied with your Stack. Align the system and tighten all TM Clamps to ensure that your “Smokers ” exhaust system remains properly aligned. 11.