Removal of Stock System: 1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from the rubber hangers and remove the system from under the truck. Figure 1 2. Using a 15mm socket or wrench, remove the (2) bolts at the turbo flange and remove the stock down pipe. Installation of MBRP Inc. Figure 2 “Smokers”: 1.
6. Loosely attach the Mounting Brackets to the front of the truck bed using the 3/8” hardware supplied. Set the Stacks up in the bed and loosely attach them to the Mounting Brackets. Make sure the Stacks are in the desired position and the T-Pipe Assembly is level. Figure 5 Figure 6 7. Mark the bed floor where the T-Pipe is resting. MBRP Inc. recommends tracing around where the T-Pipe meets the bed floor. Refer to Figure 5. Remove Stacks and T-Pipe Assembly from the bed of the truck.
System shown in pictures is 4” with 36” Stacks (B1410) Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your MBRP Inc. S8116 © 10/09 “Smokers” Smokers”: We are certain you will enjoy your purchase.