Installation guide

Installation Guide 77
6
Post-Installation Procedures
The procedures you need to complete after you install the new version of the
software depend on whether you are migrating existing information from McAfee
AutoUpdate Architect 1.0 or AutoUpdate 7.0, and whether you are installing the
software for the first time or upgrading from version 2.0, 2.5, or 2.5.1. Regardless,
you need to complete the following procedures after you install the software:
n Post-installation best practices guidelines on page 78.
n Which files you need to check in manually on page 79.
n Deploying product plug-in files on page 79.
n Determining which products can be managed on page 80.
n Determining which products and product updates can be deployed on page 80.
If you are upgrading from version 2.0, 2.5, or 2.5.1, you also need to complete these
procedures after you install the software:
n Agent AutoUpgrade on page 81.
n Where the installation stores custom report templates on page 81.
Migrating information from McAfee AutoUpdate Architect 1.0
If you are migrating existing information from McAfee AutoUpdate Architect 1.0,
you also need to complete these procedures after you install the software:
n Importing McAfee AutoUpdate Architect 1.0 repositories on page 82.
n Verifying configuration settings for repositories on page 84.
n Defining proxy server settings on page 85.
Migrating information from AutoUpdate 7.0
If you are migrating existing information from AutoUpdate 7.0, you also need to
complete these procedures after you install the software:
n Verifying configuration settings for repositories on page 84.
n Removing AutoUpdate 7.0 policies and tasks after agent deployment on page 86.