Use and Care Manual

ENGLISH

STEAM CLEANING ACCESSORIES

WARNING: Do not connect accessories while unit is emitting steam.

JET NOZZLE / SCRAPER / TRIANGLE BRUSH

1. Select one of the three accessories (Jet Nozzle shown as example) and push onto the Steam

Nozzle (A).

2. Rotate accessory until the yellow lock/release button snaps into the accessory hole (B).

NOTE: The Jet Nozzle, Scraper and Triangle Brush can be connected to the end of an

Extension Wand for reaching high or difcult spots. Connect the Extension Wand (or

Wands) as outlined on Page 8, then connect your desired accessory to the Wand in the

same way as you would normally connect to the Steam Nozzle.

UTILITY BRUSHES / ANGLED NOZZLE / SCRUB PAD

NOTE: Accessories connect to the Jet Nozzle, not the Main Nozzle.

1. Firmly press accessories onto tip of Jet Nozzle. Press it on as far as possible to prevent

steam leakage.

2. To remove accessories, simply grip it rmly and pull it off Jet Nozzle.

Assembling Your Canister Steam

System

Steam Nozzle