Use and Care Manual

ENGLISH

Using Your Canister Steam System

STEAM MOPPING

NOTE: Be sure that Boiler has been lled and that all steam mopping accessories are con-

nected before following these steps.

It is recommended to sweep or vacuum hard oors before mopping.

1. Follow Steps 1-3 of General Operation section above.

Refer to Page 9 for a listing of hard oor surfaces that are recommended for cleaning

with the Canister Steam System.

2. For best results, use a continuous back-and-forth motion over oor surface, pushing the Mop

Head away and pulling it back towards you. Work your way backwards over the oor, in order

to avoid walking over freshly mopped areas.

NOTE: To avoid warping or damage caused by heat and moisture, do not use on un-

sealed hardwood or unglazed ceramic surfaces. Steam may remove the sheen from

some oors that have been treated with wax.

3. The Microber Pad will absorb dirt and moisture during mopping. However, when you are

nished you may nd some residual moisture has been left behind. In this case, it is recom-

mended to allow oor time to air-dry. A fan may be directed towards mopped area to facilitate

drying.