Service manual

Commercial in confidence
SMARTFIND NAVTEX service manual Page 37
Introduction and Scope
This Sea Trial Checklist is designed to prove that the GMDSS NAVTEX receiver is
working to specification in the installation to be evaluated.
SMARTFIND GMDSS NAVTEX is a shipborne radio receiver designed to receive
NAVTEX information, which consists of messages concerning weather and shipping
conditions. The messages are transmitted by land-based transmitters on one of three
frequencies: 490kHz, 518kHz or 4.2095MHz. Three separate receiver circuits allow
for simultaneous reception of each NAVTEX channel.
System Details
Subject
Detail (or strike out)
Date
Engineer
Vessel type
Unit serial number (rear label and in
software under ‘setup mode’ screen).
Software version (check on boot up
screen)
(0.1.0)
Or other
Antenna type, bracket and cable detail.
(ANA1) (ANA2) (Active) (passive) (wire)
Other;
PSU (12V / 24V / ac
–
dc converter etc)
(AC) (UPS) ( DC Reserve Radio Supply)
IBS connected
(RS422) (RS232 with converter)
Type;
GNSS NMEA provide by
GPS / IBS make & type;
UTC data provided by GNSS
(None)( ZDA) (GLL) ( RMC)
(GGA)
Printer type (option)
(None) (DPU 414) (other
-
)
Installation notes.
Location of main unit;
Location of antenna
Approximate cable lengths to; antenna / IBS / printer;
Safety Grounding point; (green rear wire connected to ships hull); Yes/No
DC isolator switch location;
Interfaced optional equipment; (GNSS) (IBS) (printer) (PC)