Troubleshooting guide

23
Outlook
Features
This controller has a Power LED indicator, IR receiver, a LCD display panel, 5VDC power supply input, and
one or two ways communication input/output port.
v Cool/Heat/Fan/Dry/Auto modes
v Auto/High/Med/Low fan speed
v Temperature operate in °C or °F
v Room temperature display (optional)
v Sleep function
v Swing function
v Real-time clock and Day display
v 3 Events 7-day programmable timer
v Error indicator
v Key lock and Fan lock features
v Last state memory (Memory backup setting from main board)
v Override function
4
3
2
1
5
6
7
8
Netware 3
Operating Guide
1. “ON/OFF” Switch
 • Pressoncetostarttheairconditioningunit.
 • Pressagaintostoptheunit.
 • Theoperationlampnexttothekeylightsupandgoesoffrespectivelywhentheunitis
running or not running.
 • Caution:InthecasewhentheON/OFFkeyispressedimmediatelyaftertheoperationis
stopped, the unit will not restart until 3 minutes later to protect the compressor.
2. Selecting Operating Mode
 • PresstheMODEkeytoselectthetypeofoperatingmode.Consecutivepressofthekey
switches the operation over “COOL”, “HEAT”, “AUTO”, “DRY” and “FAN”
3. Fan Speed Selection
 • PresstheFANkeyuntilthedesiredfanspeedisachieved.
1. Time display
2. Key lock display
3. Error indication
4. Fan speed display
5. Operation mode display
6. Sleep mode display
7. Air swing display
8. Temperature set display