Specifications

83
Remote Controller Operation Guide
G7 Remote Controller
On/Off Button
• Press once to start the air
conditioner.
• Press again to stop the unit.
Temperature setting
• To set the desired room
temperature, press the button to
increase or decrease the set
temperature.
• The temperature setting range is
from 16°C to 30°C (Optional
setting 18°C to 30°C).
• Press both buttons simultaneously
to toggle the temperature setting
between °C and °F.
Operation mode
• Press the MODE button to select
the type of operating mode.
• For cooling only unit, the available
modes are : COOL, DRY & FAN.
• For heat pump unit, the available
modes are : AUTO, COOL, DRY,
FAN & HEAT.
Fan speed selection
• Press the button until the desired
fan speed is achieved.
ON timer setting
• Press the SET button will activate
the on timer function.
• Set the desired on time by
pressing the SET button
continuously. If the timer is set to
7.30am, the air conditioner will turn
on at 7.30 sharp.
• Press the CLR button to cancel the
on timer setting.
OFF timer setting
• Press the SET button will activate
the off timer function.
• Set the desired off time by
pressing the SET button
continuously.
• Press the CLR button to cancel the
off timer setting.
Sleep mode setting
• Press the button to activate sleep
mode. This function is available
under COOL, HEAT & AUTO
mode.
• When it is activated in COOL
mode, the set temperature will be
increased 0.5°C after 30mins, 1°C
after 1 hour and 2°C after 2 hours.
• When it is activated in HEAT
mode, the set temperature will be
decreased 1°C after 30mins, 2°C
after 1 hour and 3°C after 2 hours.
Automatic air swing
• Press the SWING button to
activate the automatic air swing
function.
• To distribute the air to a specific
direction, press the SWING button
and wait until the louver move to
the desired direction and press the
button once again.
Clock time setting
• Press button + or - to increase or
decrease the clock time.
Turbo function (optional-only applicable
to inverter unit)
• Press button for fast cooling or heating operation.
• The temperature will be increased internally if it is in
the HEAT mode, decreased if in COOL or DRY mode.
Fan speed will be increased if it is not at maximum
speed.
• The temperature & fan speed will resume to user
setting if the button is pressed again or after 20mins.
• Available under HEAT, COOL & DRY modes only.
12
Signal Transmission
indication
• Blink to confirm the last setting
has been send to the unit.
.
Transmission source
• The source where the signal will be
transmitted.
1
4
2
3
5
8
10
11
6
7
9
12