Installation Guide

INSTALLATION I:
Contact us : For support & assistance, please feel free to contact us below.
E-Mail: [e-mail] | Web: www.medinahpower.com | Ph: [phone]
Compact LED High Bay
Installation Instructions
MEDINAH
POWER
Installation Step:
Remove the new LED fixture from packaging and inspect for any damages. Handle new LED fixture with care.
CHAIN MOUNT EXAMPLE; Install the chain into the provided wire hanger. Secure the other end of the chain to a
structure using hardware rated for the load.Install the wire hanger onto the side of the top ETLB6 LED channel.
Make sure the wiring hangers are fully engaged into the side holes on the top channel.
Connect the LED high bay wiring to line wire, black to black, white to white and green to green. Use only UL listed wiring.
**NOTE: Purple and grey lead inside the driver compartment are 0-10V (low voltage) dimming leads. Connect
to dimming low voltage wiring only.
Clean all residues/fingerprints from the new LED high bay and lens. Double check all hanging hardware before moving
onto the next installation.
Always turn off the power supply from main circuit breaker first!
D: Pendant Hanger
E: Wire Guards
Figure 1 Figure 1