User`s manual

SWAP FUNCTION

The Swap Function enables you to change between two channels positioned separately or

to switch back to a preferred channel fast. For example, if you want to switch channels dur-

ing an advertising break, you can switch back quickly at any time, by pressing the RTN

Button, to see whether the advertising break has already finished and your desired pro-

gram is continuing. Each further operation of the RTN Button will lead to a switch between

the channel most recently viewed and your preferred channel.

ESTABLISH SWAP CHANNEL (PREFERRED CHANNEL)

Variation 1: Press the MENU Button to call up the Main Menu. Position the Selection Bar on

SWAP FUNCTION by means of the P+/P- Buttons and press the MENU Button

again. You can choose between MANUAL/ 3 MIN/ 5 MIN/ 10 MIN settings with

the VOL+/VOL- Buttons or through a Menu that can be reached by means of

the MENU Button.

The Swap Channel must be defined in accordance with Variation 2 in the case

of the MANUAL setting. The channel viewed is automatically defined as the

Swap Channel after the period has expired whenever a period of time is set.

SWAP CH will be faded in into the left upper corner. Now, you will be able to

select any other channel slot and switch between the channel viewed and your

Swap Channel by pressing the RTN Button for a short time. The channel that is

your preferred channel will be displayed for 4 seconds at each channel change.

Variation 2: Press on the channel slot to which you want to revert quickly as long as the

RTN Button appears, until SWAP CH OSD is faded in. You will now have estab-

lished your preferred channel manually.

However, if a period of time has been set in the SWAP FUNCTION Menu, your

preferred channel will change automatically with your television viewing.

REVERTING TO THE FACTORY SETTING

This function sets all settings of the TV, such as brightness, colour, contrast, sharpness and

white balance, etc. back again to the status of delivery from the factory.

1. Press the MENU Button to reach the Main Menu.

2. Select the INSTALLATION Point with the P+/P- Buttons and press the MENU Button

again.

3. Select the FACTORY SETTINGS Point with the P+/P- Buttons and press the MENU But-

ton again. Now, select SET and confirm this selection with the MENU Button.

Note: You can set most important picture and sound (brightness, colour, contrast, volume)

settings back to the factory settings by pressing the RESET Button for a longer period.