Instruction manual

25
GB
3 Getting Started
1. You can set the date and time by pressing down the TIMER button

for
several seconds until appears on the display.
2. Press the TIMER button

again. After you release the button,
appears on the display and appears below this.
3. Press the TIMER button

again. and appear in the display. You
can switch the radio clock on or off by pressing the MEMO button

.
If the radio clock is switched off, you can press the TIMER button

to set
the time manually.
4. The selected user memory appears on the display together with the flash-
ing year.
- Press the TIMER button

again to display the date; the month starts
to flash.
- Press the TIMER button

again and the day starts to flash.
- Press the TIMER button

again to display the time. The hour starts to
flash.
- Press the TIMER button

again and the minutes start to flash.
- You can set the current date and time (year, month, day, hours and min-
utes) by pressing the MEMO button

and confirm the date and time
with the TIMER button

. Then the date and time you set are shown
twice each in succession before the device returns to standby mode. In
standby mode, the time is displayed permanently.
NOTE
If, during manual time setting, you press the START button

,
you exit the time setting mode.
The date and time values you have entered so far are kept.
“ - : - - “ is displayed if you did not set the time previously.
Your MEDISANA MTX blood pressure meter is equipped with an alarm func-
tion, with which the two users can set three alarm times each, in order to take
medication are regular intervals, for example.
Make sure that the device is in standby mode and your own user memory

has been selected.
1. Press the TIMERbutton

followed by the MEMO button

. Hold down
both buttons until the alarm symbol

appears on the display.
2. Release both buttons. “ 1 “ flashes at the bottom right of the display for
Alarm 1. You can use the MEMO button

to select Alarm 1, Alarm 2 or
Alarm 3.
3. Press the TIMER button

. The display for entering the alarm time flash-
es. Use the MEMO button

to enter the alarm time: first the hours and
then the minutes.
3.4
Setting the alarm
51083_MTX_West_Final_08.06.qxd:Blutdruckmessgerät 08.06.2013 12:39 Uhr Seite 25