User guide

10 Click the Choose Port drop-down menu, and select the port that the ComLink, Paradigm Link
®
,
CareLink USB, or Com-Station connects to on your computer. If you are not sure which port to
choose, select Auto Detect (or USB).
11 Click NEXT. The Test Connection page similar to the following is displayed.
12 Follow any device instructions, and click TEST.
A message displays to let you know if the connection was successful. If it was, go to the next
step.
NOTE: This Test does not read pump data, but verifies correct communications between
the pump and the computer.
If not, make sure the hardware between the device and the computer is connected properly.
Also, click BACK on the pages of the wizard to make sure the device data you have entered is
correct.
13 Click DONE.
The device is added to the patient’s Active Devices list.
Adding a meter
1 Click the patient’s tab or double-click their name on the Patient Lookup table.
2 Make sure the meter you are adding is in communication with the computer. (See Chapter 5,
Hardware setup for connection steps.)
3 Click the Devices button to access the patient’s Devices workspace.
4 Click the ADD DEVICE button.
CareLink Pro User Guide Devices workspace 32