- Mega System Technologies iCAMView Web Server User Manual For models: iCV-01a , iCV-01b, iCV-02, iCV-03

iCAMView user manual -20-

Chapter 5: iCAMView Web Manager

Section 1. Introduction

After you have setup the hardware and set an IP address for iCAMView, you will then

be able to go to iCAMView web site to monitor and control the PC cameras. All you

have to do is enter the new IP address into any web browser.

1. Start the Web Brower (Netscape or Internet Explore)

2. Enter the iCAMView IP Address that was set earlier using “Setup Wizard” (e.g.

192.168.0.30, if you do not remember, goto to iCAMView and look at the LCD

display) and press ENTER

Fig.13. Enter iCAMView IP address

3. A login screen will appear. Enter the Administrator User Name and Password if

you have set these in the “Setup Wizard”. Otherwise, just press ENTER.

Fig.14. iCAMView Login screen

Section 2. iCAMView Web Manager Interface

The iCAMView webpage main menu is divided into two sections. The selection menu

on the left and display menu on the right. The selection menu consists of the following

options:

2.1 Web-Camera Selection