Instruction manual

¨Maintenance
¨Operation regulations
A.Install activated charcoal sachet
1.Soak a new activated charcoal sachet in water to
remove dust.
2.Turn the bottle lid with the hole, and unscrew it from
the nozzle compartment.
3.Fold the activated charcoal sachet in half, and put it
into the nozzle.
4.Reassemble the lid.
5.Put the lid with the hole onto the collection bottle,
lining it up with the spout on the distiller.
NOTE: Each activated charcoal sachet can be used for up to a month.
Please replace it regularly. The activated charcoal dust is harmless
and functions as removing odors and raising the taste of water.
B.Filling the distiller with water
C.To distill water
1.Pour water into the distiller boiling chamber and be careful not to fill over the
internal "fill line"(about 5cm from the top).
2.If you use hot water from a kettle, the total distillation time shall be reduced.
1.Pull the upper cover from the boiling chamber, allowing for the plug.
2.Pour water into the stainless steel boiling chamber. *Make sure not to fill past
the line marked inside the boiling chamber.
3.Place the upper cover on the distiller. *Be sure that any spillage outside the
distiller is dried off, and the electrical sockets are dry before plugging the power
cord into the socket on the distiller.
4.Line up the lid with the hole on the collection bottle with the distiller nozzle.
Insert the main power cord into the power socket, and turn the power switch on.
* You will hear the fan start to function immediately.
5.The RESET button on the distiller is set by the factory at "ON" position.
6.For subsequent cycles, please press firmly on the RESET button when
distillation starts.
7.About an hour after you switch on power, distilled water will begin to drip into
the storage tank.
8.The power supply shall switch off automatically when distillation is completed.
*Never remove the upper cover while the distiller is on. Turn off power supply if
wish to stop the distillation process.
Lid
Activated
charcoal sachet
Nozzle
Never use abrasive cleaners or brushes on you
distiller.
After each cycle rinse the inside of the boiling
chamber with tap water. Do keep the outside dry.
To remove the buildup of deposits, follow the
instructions on the distiller cleaning crystals
enclosed. Use it once a week or more, depends on
the scale buildup in the boiling chamber.
If it appears to have a peeling stainless steel, it
needs a clean right away.
The activated charcoal sachet should be replaced
once a month or earlier.
If the condensing coil is clogged with dust, the
efficiency of distillation many be affected. To clean
the condensing coil, vacuum the coil regularly
through the slots in the upper cover.
*All chambers have the "welding spots" in the
bottom of the bowl. This is normal.
Q: Why my distiller is not making any water?
Q:My distiller is not making enough water during each cycle, and steam is
leaking from spout, why?
Please check the main power cord and make sure it is plugged in as well as the
upper cover cord is plugged in the base of distiller.
Please make sure:
1. Raw water is filled to the mark line inside the boiling pot.
2. Be sure the proper sitting of the upper gasket.
3. Do place the water collection tank directly under the spout.
4. Condensing fins are clean and not blocked with dust.
5. Fan is working
6. Charcoal sachets are placed in the nozzle properly.
¨FAQ
MH-943 WATER DISTILLER MH-943 WATER DISTILLER