Product specifications

530.PROD.GB.3 : 530.INST.FFIND.NONE.NONE.GB.1 Black 61
©, MEI., 1994.61
CashFlow

530 Changegiver Product Maintenance Handbook
Unit rejects one type of coin or token
Coin or token is inhibited. Coin or token is damaged or worn. A tube has reached pre- set float level, further coins are rejected because the unit is in float mode.
Check the coin/token is in the coin set, and has been enabled. Use the Route Alpha 250 terminal to enable the coin. Discard the worn or damaged coin/token. Press A to leave float mode and to clear any credit. Check the tube levels, then make a vend to check that the correct change is dispensed.
Coins are not routing correctly
The level of coins in a tube is covering a top- level sensor. The top-level sensor loom or the separator loom is not connected correctly. Wrong acceptor or separator is fitted. A tube is disabled.
Check tube counts. If they are above the pre-set float levels and automatic tube inventory is set, press Mode+A+C to float-down the coins in the tubes. Switch off the power, remove the cassette and release the acceptor. Check that the top-level sensor and separator looms are fitted correctly. Replace the acceptor and cassette. Switch on power to the unit, insert coins and check routing. Check that the acceptor and separator are the correct versions. Refer to your authorised MEI distributor. Use the Route Alpha 250 terminal to enable the tube.
Problem Causes Actions