Product specifications

530.PROD.GB.3 : 530.INST.FFIND.NONE.NONE.GB.1 Black 63
©, MEI., 1994.63
CashFlow

530 Changegiver Product Maintenance Handbook
Red LED is ON but coins are not accepted
Coin jam in the changer mechanism. Lid of the acceptor is open. Not enough reject lever clearance.
Check for jams in the acceptor and in the tubes. Clear the jams. Press Mode + Mode to park the dispenser arms before replacing the cassette, then dispense a coin from each tube to check operation. Switch off the power to the machine. Open and close the lid of the acceptor, wait at least 15 seconds, then switch on again. Check clearance is between 2 - 3mm, and adjust if necessary.
Red LED stays OFF
No power to the unit, or voltage not correct. No power to the unit, loose loom or blown fuse.
Check that the power supply to the changegiver is at the voltage shown in the window on the keypad label. Test the power supply by pressing the Mode button. If the yellow LED flashes, the power is ON. If yellow LED stays off, switch off power to the machine, and check all power looms and fuses. Replace any blown fuses. Restart the machine and check that the red LED is on.
Red LED is OFF, but change coins are routed to the cashbox and not to the tubes
Mismatch between the true coin count in a tube and the count being registered by the changegiver
Press and hold down A, B, C and D for at least three seconds each to dispense coins down to the tube safe counts. Press Mode + A + B, and insert change coins through the acceptor until tubes reach their pre-set levels.
1
If an audit FEM is fitted, Mode+A+B is not available to reset tubes automatically to pre-set levels. In this case, float tubes to required levels and make a trial vend.
Problem Causes Actions