ITEM NO.
Thank you for purchasing this product. Please read this manual carefully before use and retain it for future reference. Technical parameter of the helicopter Fuselage Length:235MM Gross Weight: about 49g Main Rotor Diameter: 225MM Overall height: 80MM Battery: Li-polymer 3.7V Motor: N30 Gear Ratio: 8:1 Tail Rotor Diameter: 50MM Charging Time: about 70 minutes Introduction With single-rotor design and built-in gyro, the helicopter is more flexible and much stronger.
Product/spare parts included in this packaging Description Helicopter Remote controller Rotor blade Qty(pc) 1 1 2 Qty(pc) Description 3.7V 380mAh li-polymer battery 2 Manual 1 Tail Rotor 1 USB charger 1 The LCD Remote controller Main features of the remote controller 2.4G, LCD reomote control, scores of helicopters can be played at the same time. Control function:upward,downward, forward, backward,leftward, rightward, turning left and turning right.
No. Function switch Function description 4 Trimmer B In stick Mod 3 and 4, it helps to tune the helicopter's sideward flight. In stick Mod 1 and 2,it helps to tune the helicopter's left and right direction turning speed. 5 Trimmer C In stick Mod 3 and 4, it helps to tune the helicopter's left and right direction turning speed. In stick Mod 1 and 2,it helps to tune the helicopter's sideward flight. 6 Trimmer D In stick Mod 1 and 3, this button is null.
键 Pic.1 Pic.2 键 Activate the LCD remote controller Slide the power switch to "ON" position after throttle control stick selection is done.To activate the remote controller, slowly push up the throttle control 键 stick to the top and then push it down to the bottom. The remote controller is activated once a beep sound is heard. Then, the indicator light keeps flashing while the remote controller is sending out connectional signal. It takes about 10 seconds to finish the signal transmission process.
CH 1 STICK MOD 2 CH 1 STICK MOD 2 00 00 This is the low speed icon. Pic.7 CH 1 STICK MOD 2 00 This is the medium speed icon. EXIT/ LIGHT MENU/ OK Pic.8 PUSH This is the maximum speed icon . EXIT/ LIGHT MENU/ OK Pic.9 PUSH EXIT/ LIGHT MENU/ OK PUSH The helicopter connector stabilizer bar rotor blade Tail motor battery connector landing gear battery compartment How to charge the helicopter This helicopter is included with USB charger.
Preparation for flight Turn on the remote control. To activate the remote controller,slowly push up the throttle stick to the top and then push it down to the bottom. The remote controller is activated once you hear a beep sound.Then, the indicator light flashes rapidly while the remote controller is sending out connectional signal. Connect the battery plug to the helicopter battery cable,the indicator light of the helicopter will keep slowing flashing,set the helicopter down to a platform.
A.When the helicopter is hovering but still the elevator servo keeping flying forward automatically, connecting bar please take out the elevator servo swashplate connecting bar, then, clockwise rotate the bar for one circle(360°). How many the aileron servo coneecting bar circle should be regulated will depend Pic9 on the tilt angle of the swashplate. Generally, rotate the bar for one or two circles for one regulation.(Pic 10) B.
Trimmer Functions If the helicopter keeps moving forward/backward even there is no control signal given, users may adjust the elevator trim to keep the helicopter 键 balanced. STICK MOD 1 or 3: If the helicopter keeps moving backward, push up Trimmer A until it gains balance. 键 EXIT/ LIGHT MENU/ OK PUSH STICK MOD 2 or 4: If the helicopter keeps moving forward, push down Trimmer A until it gains balance.
键 STICK MOD 1 or 2: 键 If the helicopter keeps moving leftward, turn right of Trimmer C until it gains balance. EXIT/ LIGHT MENU/ OK PUSH If the helicopter keeps moving righttward, turn left of Trimmer C until it gains balance. If the helicopter keeps spinning even there is no control signal given, users may adjust the rudder trim to keep the helicopter balanced.
Downward Push down the throttle control stick, the rotation speed of the mains rotors are decreasing and the helicopter descends accordingly. Turn left Turn the left/right turning control stick to the left,the helicopter will left. Turn right Turn the left/right turning control stick to the right,the helicopter will right. Forward When the helicopter is flying, push up the forward/backward control stick, the helicopter will move forward.
