Operation Manual

28
Indicators on the display
f. Indicator “I”
g. Indicator “II”
h. Indicator “III”
i. “½H” indicator (½ hour)
j. 1H indicator (1 hour)
k. 2H indicator (2 hours)
l. 4H indicator (4 hours)
m. “NM” indicator (normal)
n. “NT” indicator (natural)
o. “SL” indicator (sleep)
PRIOR TO FIRST USE
• Remove all packaging and transport
material from the appliance.
• Check that the appliance has no
visible damage and that no parts
are missing.
• Clean the appliance before using it
(see the section “Cleaning” below).
• Assemble the appliance before use
following the instructions below.
1. Place the appliance on
its side.
2. Place the cord between
the two halves of the
base (6) and assemble
the base by inserting the
round dowels on one
half into the collector
rings (7) on the other
half. Ensure the two
halves are perfectly
level and that the cord
moves freely through
the hole at the centre of
the base.
3. Pass the cord through
the groove (5) at the
edge of the base and
secure it by pushing
it underneath the two
holders (see picture I.).
1. Place the base against
the bottom of the
appliance so the holes in
the base align with the
holes in the appliance.
Join the two parts
together using the 4
screws (see picture II.).
2. Stand the appliance on
its base. The appliance
is now ready for use.
Placing battery in the remote control
1. Turn the remote control so that the
back is facing upwards.
2. Remove the battery holder (p) by
pressing the pin on the left side
down and pulling the holder out.
3. Insert 1 x battery type CR2025
(button cell battery) with plus pole
facing upwards in the battery
holder (see diagram on back of
remote control).
4. Push the battery holder back into
place in the remote control.