Operation Manual

Problems
44
ENGLISH
Removing the water lter
The water lter should not be left standing dry for a long period of time.
When it is not used for a long time, we recommend storing the water lter
in a vessel lled with tap water in the refrigerator.
Remove the water lter as follows:
Requirement: The ready symbol appears on the display.
1. Press the "menu/ok" button for longer than 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Filter > Remove lter menu.
3. Select Start using the arrow buttons and conrm with "menu/ok".
4. Follow the further instructions on the display.
» The water hardness is automatically reset to the previous setting.
» The ready symbol appears on the display.
5. Re-adjust the water hardness if necessary, (see section 9.8 Setting the
water hardness on page41).
10 Problems
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
United Kingdom: +44 (0)800/ 0288 002
Problem Cause Action
Coee only emerges
in drips from the
outlet.
Grinding neness
too ne.
 Set a coarser grinding neness (see
section 8.7 one page35).
Appliance soiled.  Clean the brewing unit (see sec-
tion9.3 one page37).
 Run the cleaning programme (see
section9.6 one page40).
Appliance is covered
inside with limescale.
 Descale the appliance (see sec-
tion 9.7 one page40).
Coee does not ow. Water tank not lled
or inserted incor-
rectly.
 Fill the water tank and ensure it is
positioned correctly (see sec-
tion4.5 one page18).
Brewing unit
clogged.
 Clean the brewing unit (see sec-
tion 9.3 one page37).