Operation Manual

15
GB
쎲 With a clean, absolutely dry dusting brush
clean...
- the lying open ends of the feed screws, see
page 14 (c), the location where you took off
the powder chutes.
- the instant containers completely
from inside and outside. Remove stuck
instant residues, if any.
Re-assembly:
Now, you can re-assemble everything in reverse
order again:
쎲 Put on the mixer flange again, however,
only turn it clockwise until reaching the first
lock-in position.
쎲 Put the mixer impeller onto the axle
such that its flattened side matches the
mark (arrow) and then push it upward to the
stop.
쎲 Now, insert the mixer housing again
and...
쎲 srew down the mixer flange clockwise
at the small lever (b).
쎲 The instant beverage hose has to be
completely pushed onto the connection
piece at the mixer unit and inserted at the
front of the beverage outflow (c).
There press it completely down.
쎲 First, re-insert the right and then the left
instant container. These containers have
been correctly inserted after the studs at
their lower side have locked into place in the
respective bores in the container compart-
ment.
쎲 Before closing the appliance door, do not
forget to insert the powder chudes and to
turn them downward in the funnel at the
mixer housing.
26
25
24
27
25
2019