Operation Manual

58
Energy-saving stand-by mode
The appliance switches to energy-saving standby mode automatically (temperature is
lowered to save energy) after the last action (depending on the setting). For this you
can set the timer to different times. See page 59 for more information in this regard.
Stand-by mode
In stand-by mode the appliance consumes very little energy (< 1 W). However, we
recommend switching the appliance off via the power switch if it will not be used
for an extended period (e.g. also overnight). The appliance automatically switches to
stand-by mode one hour after the last action. You can set the timer for a different
time. See page 60 for more information in this regard.
9 Function settings
Setting the water hardness category – function setting 1
Use the included test strip to determine the water hardness in your area. Please com-
ply with the instructions on the test strip packaging.
Water hardness is set to 4 in the factory.
To maintain appliance quality please adjust the water hardness as follows:
Prerequisite: The appliance must be in stand-by mode.
The on/off button
will be illuminated red.
Simultaneously press the button for single-cup dispensing and the but-
ton for steam dispensing
, until the four buttons are faintly illuminated.
Press the button for steam dispensing several times
to select between
the possible water hardness categories.
The button for steam dispensing will be brightly illuminated. Your selec-
tion of water hardness category in accordance with the table is indicated via
the bean symbols in the display.
→
•
•
→