Owners Manual

Cargo Van/Passenger Van
Bolt covers for the safety catches (example: Cargo
Van)
X
Open the tailgate.
X
Apply a screwdriver to recesses ; and
then pry off covers :.
X
Using the lug wrench from the vehicle tool
kit (Y page 184), unscrew the now visible
bolts counter-clockwise by approximately
20 turns.
X
Slightly raise spare wheel carrier A and
unhook left-hand safety catch =.
X
Assemble the pump lever for the jack and
slide it into sleeve ? on spare wheel
carrier A.
X
Raise spare wheel carrier A with the pump
lever and unhook right-hand safety catch
=.
X
Slowly lower spare wheel carrier A down
to the ground.
X
Lift spare wheel carrier A slightly and pull
the pump lever out of sleeve ?.
X
Use the pump lever to lift the spare wheel
beyond the rear edge of the spare wheel
carrier.
X
Carefully remove the spare wheel from the
bracket.
G
WARNING
When the spare wheel is removed, the center
of gravity changes due to the heavy weight of
the wheel. The spare wheel could slip off or
tip and cause injury to yourself or others. Pull
the spare wheel out carefully. Take care not
to trap your fingers when lifting out the spare
wheel.
Cab Chassis
X
Loosen wing nuts = manually and then
remove them.
X
Loosen nuts ; as far as the thread end.
X
Slightly raise spare wheel carrier ? and
unhook left-hand safety catch :.
X
Assemble the pump lever for the jack and
slide it into the sleeve on the right-hand
side of spare wheel carrier ?.
Where will I find...?
187
Practical advice
Z