Owners Manual

If you wish to install telephones or two-way
radios in the vehicle, you must obtain formal
approval. Further information can be
obtained from any Sprinter Dealer.
!
Damage or consequential damage arising
from installing equipment which is not
approved by the distributor named on the
inside of the front cover is not covered by
the New Vehicle Limited Warranty.
For operation of mobile phones and two-way
radios, we recommend connection to an
approved exterior antenna. This is the only
way to ensure optimum reception quality
inside the vehicle and to minimize mutual
interference between the vehicle electronics,
mobile phones and two-way radios.
G
WARNING
You and others may damage your health due
to excessive electromagnetic radiation. By
using an external antenna, the possible health
risks of electromagnetic fields, which are
under discussion among the scientific
community, should be largely prevented.
Therefore, only have the exterior antenna
installed at a qualified specialist workshop.
The transmission output of the mobile phone
or two-way radio must not exceed the
maximum transmission outputs listed.
Frequency range Maximum
transmission
output (PEAK)
Short wave
(f < 50 MHz)
100 W
4 m waveband 30 W
2 m waveband 50 W
Trunked radio/Tetra 35 W
70 cm waveband 35 W
GSM 900/AMPS 10 W
GSM 1800 10 W
UMTS 10 W
Identification plates
Vehicle identification plates
The vehicle identification plate with the
vehicle identification number (VIN), the paint
code, and the specifications for the
permissible weights is located on the base of
the driver's seat.
Base of the driver's seat
:
Vehicle identification plate with VIN for
vehicle or chassis
The VIN is also stamped into the rear wall of
the engine compartment (Y page 286).
Example: vehicle identification plate (US vehicles)
;
VIN
=
Paint code
Identification plates
285
Technical data
Z