Owners Manual

Head restraints
Important safety notes
G
WARNING
Only drive with the head restraints installed
and adjusted correctly. You could otherwise
suffer serious or fatal injuries in the area of
the upper spinal column.
Adjust your head restraint so that its upper
edge is at the same level as the top of your
head. The back of your head should be as
close as possible to the head restraint when
relaxed, so that your head can be properly
supported in the event of an accident.
The head restraint must be engaged in a
detent.
Adjusting the head restraints
Head restraint (example: luxury head restraint on
the co-driver's seat)
:
Release button
;
Head restraint height
=
Head restraint angle (luxury head
restraints only)
X
To raise: pull the head restraint up to the
desired position.
X
To lower: press release button : and slide
the head restraint down to the desired
position.
X
To adjust the angle: hold the head
restraint by the lower edge and tilt it to the
desired position.
Removing the head restraints
X
Pull the head restraint up to the stop.
X
Press release button : and pull out the
head restraint.
Installing the head restraints
!
Install the head restraints with the front
side facing forwards (luxury head
restraints).
X
Insert the head restraint so that the rod
with the detents is on the left.
X
Push the head restraint down until it
engages.
Armrests
X
To set the armrest angle: fold the armrest
upwards ; by more than 45°.
The armrest is released.
X
Fold the armrest forwards = to the stop.
X
Slowly fold the armrest upwards to the
desired position.
X
To fold the armrest up: if necessary, fold
the armrest upwards : by more than
90°.
Seat heating
G
WARNING
Repeatedly setting the seat heating to level
3 may result in excessive seat temperatures.
The health of passengers that have limited
Seats
71
Controls
Z