Owners Manual

Lighting submenu
Setting daytime running lamp mode
If you have set daytime running lamp mode
and the light switch is in the $ position,
the following light up automatically when the
engine is running: the parking lamps, the low-
beam headlamps, the tail lamps and the
license plate lamps.
For safety reasons, it is only possible to
change this setting when the vehicle is
stationary. The factory setting is Constant in
countries in which daytime running lamp
mode is mandatory.
Using the steering wheel buttons
X
Press the V or U button repeatedly
until the Settings menu appears in the
display.
X
Press & to switch to the submenu
selection.
X
Press W or X to select the
Lighting submenu.
X
Press & to select the Hdlmp mode
function.
The selection marker is on the current
setting.
X
Press W or X to select the Manual
or Constant (daytime running lamp mode)
setting.
i
USA only:
If you turn the light switch to T or
L, the corresponding light is switched
on. Daytime running lamp mode remains
activated if the light switch is turned to
Ã.
Canada only:
If you turn the light switch to L, the low-
beam headlamps are switched on. Daytime
running lamp mode remains activated if the
light switch is turned to T or Ã.
i
For safety reasons, it is not possible to
reset the Hdlmp mode function to the
factory setting while the vehicle is in
motion. You will see the following message
in the display: Setting only possible
at standstill
Switching surround lighting (locator
lighting) on/off
If you switch the surround lighting to On, the
following lamps light up in the dark after you
have unlocked the vehicle using the key:
R
the parking lamps
R
the tail lamps
R
the license plate lamps
R
the fog lamp
The surround lighting automatically switches
off after 40 seconds or when you:
R
open the driver's door
R
insert the key into the ignition lock
R
lock the vehicle using the key
Using the steering wheel buttons
X
Press the V or U button repeatedly
until the Settings menu appears in the
display.
X
Press & to switch to the submenu
selection.
X
Press W or X to select the
Lighting submenu.
X
Press & to select the Loc. lighting
function.
The selection marker is on the current
setting.
86
On-board computer with steering wheel buttons
Controls