Installation & Assembly

Instructions: How to Install Peel & Stick Wallpaper
Get ready to learn how to hang Peel & Stick Wallpaper. Simply peel away and then stick anywhere. The best part is, it is
completely removable and reusable. Meant for any smooth, flat surface including walls, doors, entryways, cabinets, stairs,
furniture, frames, mirrors and more, never has decorating your space been easier or more fun. Follow our step-by-step detailed
hanging instructions below to get started.
Gather the Recommended Tools
When applying Peel & Stick Wallpaper, we recommend the following tools:
• Sponge and gentle cleaner (to clean the wall)
• Tape Measure
• Level
• Steel Ruler or Straight Edge
• Razor Knife
• Scissors
• Pencil
• Plastic Smoother
Surface Preparation
For best results, clean, dry and smooth all surfaces. Product will not adhere to unclean or textured surfaces. Allow newly painted
surfaces to fully cure for a minimum of 4 weeks before applying Peel and Stick Wallpaper.
Step 1: Prep the Wall
Before you begin installing your peel and stick wallpaper, prepare your surface and clear the work area. Make sure electrical
outlets are off and remove wall fixtures. For best results, clean and properly prepare all wall surfaces with a sponge and all-
purpose cleaner. Old wallcoverings and paste residue should be removed.
Step 2: Measure
Beginning on the left side of your wall, measure out from the corner the width of the paper (20&1/2”) and mark the wall lightly
with a pencil. Put your level on this mark and draw a straight, level, vertical line. This is the guide for your first strip, it is very
important for it to be level. Remember to allow an extra inch or two for trimming both the top and bottom.
Step 3: Peel Backing Off and Position
Peel about 12” of the backing away from the paper. Apply the paper to the top of the wall, allowing a bit of excess to overlap the
ceiling which will be trimmed off later. Align the right side of the strip to your mark and lightly press the edge to the wall along
the mark. You can reposition if needed to ensure a vertical seam.
Step 4: Apply Peel and Stick Wallpaper
Working from top to bottom, pull the backing away as you evenly press the paper to the wall. Do not force, let gravity assist you.
Be careful not to pull or stretch the material or the pattern will not align. For best results , have one person guide the paper at the
top and along the seam, while another holds the opposite edge away from the wall until the seams are lined up.
Step 5: Smooth Wallpaper Down the Wall
Using a plastic smoother, work your way down the strip in a back and forth motion, smoothing the material to the wall and
pushing out any air bubbles. Trim off excess material at ceiling and baseboard with a straight edge and sharp razor knife.
Step 6: Repeat
Repeat procedure aligning your next strip to the right edge of your previous strip.
WE highly recommend 2 people at the time of Installation. Straightening the wallpaper roll 2 hours prior the
installation. Do not force or pull the self adhesive, let the gravitation to do its job.