Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
DRAINING WATER FROM THE FUEL FILTER
Check the fuel filter for water accumulation or sediment. If water is in the fuel,
drain the water. If the filter appears to be contaminated, remove and replace.
1.
Read Fuel System Precautions, preceding.
2. Inspect the water‑separating fuel filter. If water is present, the red ring
inside the filter assembly should float at the water level.
3. Pull the filter assembly—including the rubber mount—off of the mounting
bracket on the engine, and swing the assembly over the edge of the
engine.
4. Loosen the drain valve until liquid flows out of the bottom. Empty the filter
bowl's contents into an approved container. To protect the environment,
immediately clean up spilled fluids and dispose according to local laws
and regulations.
NOTE: A drain hose can be temporarily installed onto the center drain port of
the drain fitting to assist emptying the contents into an approved container.
a - Mounting bracket
b - Drain valve
c - Empty contents into an approved container
a
b
c
74506
MAINTENANCE
eng 99