Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
6. Align the notch in the rubber mount with the rib on the filter housing, and
install the rubber mount.
a - Notch in rubber mount
b - Rib on filter housing
7. Install the filter assembly onto the mounting bracket.
8. Connect the fuel line to the engine and prime the engine fuel system.
Inspect the fuel filter area for fuel leaks. Repair as needed.
Gearcase Lubrication
When adding or changing gearcase lubricant, visually check for the presence of
water in the lubricant. If water is present, it may have settled to the bottom and
will drain out prior to the lubricant, or it may be mixed with the lubricant, giving it
a milky colored appearance. If water is noticed, have the gearcase checked by
your dealer. Water in the lubricant may result in premature bearing failure or, in
freezing temperatures, will turn to ice and damage the gearcase.
Examine the drained gearcase lubricant for metal particles. A small amount of
metal particles indicates normal gear wear. An excessive amount of metal
filings or larger particles (chips) may indicate abnormal gear wear and should
be checked by an authorized dealer.
DRAINING GEARCASE
1. Place the outboard in a vertical operating position.
2. Place the drain pan below outboard.
3. Remove the vent plug and fill/drain plug and drain lubricant.
a - Vent plug
b - Fill/drain plug
a
b
74509
b
a
9836
MAINTENANCE
eng 103