Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
3. Place a block of wood between the gearcase and the propeller to prevent
rotation and tighten the propeller nut. Tighten the propeller nut to specified
torque, and secure the nut to the shaft with a cotter pin.
NOTE: If the propeller nut does not align with the propeller shaft hole after
tightening to the specified torque, then tighten the nut further to align it with the
hole.
a - Nut
b - Cotter pin
c - Rear thrust washer
d - Propeller
e - Front thrust hub
f - Ring (faces toward gearcase)
g - Propeller shaft
Description Nm lb‑in. lb‑ft
Propeller nut 25 – 18.4
a
b
c
d
e
f
g
16219
MAINTENANCE
110 eng