Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
INSTALLING THE OUTBOARD ON THE TRANSOM (MANUAL TILT
MODELS)
!
WARNING
Failure to correctly fasten the outboard could result in the outboard propelling
off the boat transom resulting in property damage, serious injury, or death.
Before operation, the outboard must be correctly installed with the required
mounting hardware.
This product must be secured to the transom with the required mounting
hardware. If the outboard strikes an under water object, the required mounting
hardware prevents the outboard from propelling off the transom. A decal on the
swivel bracket reminds the installer of the potential hazard.
Avoid serious injury
or death. Secure
engine to transom
with bolts.
WARNING
37-896853-007
52375
IMPORTANT: Models not equipped with power trim or gas assist must have the
transom clamps contacting the top of the transom and the clamp screws
tightened, prior to drilling the mounting bolt holes through the transom.
1. Place the outboard on the centerline of the transom.
27005
INSTALLATION
eng 29