Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
The outboard must be secured to the transom with the two transom bracket
clamp screws and four 13 mm (1/2 in.) diameter mounting bolts and locknuts
provided. Install two bolts through the upper set of mounting holes and two
bolts through the lower set of mounting slots.
a - Bolt (4)
b - Transom clamp bolt
c - Washer (4)
d - Locknut (4)
Description Nm lb‑in. lb‑ft
Outboard mounting locknuts and
bolts
75 – 55
Remote Control Connections
REMOTE WIRING HARNESS INSTALLATION
1. Loosen seven captive screws and remove the starboard cowl.
73857
2. Connect the remote harness to the engine harness 14‑pin connector at
the top aft of the engine.
a
b
c
d
10175
INSTALLATION
34 eng