Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
3. Route the harness along the top and forward sides of the intake runner,
and secure the harness with cable ties in three locations.
a - 14‑pin connector
b - Cable ties
c - Remote harness
THROTTLE CABLE INSTALLATION - RC MODELS
Install cables into the remote control following the instructions provided with the
remote control.
1. Move the remote control handle from neutral into forward and advance
the handle to full speed position.
NOTE: The throttle cable is the second cable to move when moving the
control box out of neutral.
2. Install the throttle cable onto the throttle actuating lever. Secure with a
plastic washer and cotter pin.
a
b
74441
c
INSTALLATION
eng 35