Product Manual

3. Adjust the throttle cable barrel so that when the barrel is installed into the
barrel support bracket, no play can be felt when lightly pushing the throttle
cam with a finger.
a - Throttle actuating lever
b - Cotter pin
c - Plastic washer
d - Throttle cam (no play can be felt when lightly pushing)
e - Throttle cable barrel
f - Barrel support bracket
4. Slowly return the remote control handle back to the neutral detent
position.
5. Move the throttle control back and forth, to check for proper operation.
SHIFT CABLE INSTALLATION - NON-JET MODELS
Connect cables to the remote control following the instructions provided with
the remote control.
1. Locate the center point of the slack or lost motion that exists in the shift
cable as follows:
a. Move the remote control handle from neutral into forward and advance
the handle to full speed position. Slowly return the handle back to the
neutral. Place a mark ("a") on the cable end guide.
b. Move the remote control handle from neutral into reverse and advance
the handle to full speed position. Slowly return the handle back to the
neutral. Place a mark ("b") on the cable end guide.
a
b
c
d
e
f
74479
INSTALLATION
36 eng