Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
c. Make a center mark ("c"), midway between marks "a" and "b". Align
the cable end guide with this center mark when connecting the cable
to the engine.
6098
b
c
a
2. Ensure that both the outboard engine and the remote control are in
neutral.
3. Install the shift cable onto the shift actuating lever. Secure the connection
with a plastic washer and cotter pin.
4. Adjust the cable barrel so the center mark on the cable guide is aligned,
when the shift cable barrel is in the barrel support bracket.
a - Cotter pin
b - Plastic washer
c - Shift lever
d - Center mark on shift cable, aligned with end of shift cable sleeve
e - Barrel support bracket
f - Barrel
5.
Check shift cable adjustments as follows:
a
b
c
d
e
f
74355
INSTALLATION
eng 37