Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
a. Shift remote control into forward. The propeller shaft should be locked
in gear. If not, adjust the cable end accordingly.
b. Shift remote control into reverse while turning propeller. The propeller
shaft should be locked in gear. If not, adjust the cable end accordingly.
Repeat steps a through c.
c. Shift remote control back to neutral. The propeller shaft should turn
freely without drag. If not, adjust the cable end accordingly. Repeat
steps a through c.
6. Install the throttle and shift cable retaining bracket, and secure it with a
single screw with washer. Tighten the screw to the specified torque.
a - Throttle and shift cable
retaining bracket
b - Screw with washer
Description Nm lb‑in. lb‑ft
Screw 10 88.5 –
7. Install the rigging grommet.
8. Install the starboard cowl and secure it with the seven captive screws.
Tighten the screws to the specified torque.
73857
a
b
74477
INSTALLATION
38 eng