Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
• The fuel tank includes a fuel demand valve that prevents pressurized fuel
from entering the engine and causing a fuel system overflow or possible
fuel spillage.
• When installing the fuel tank cap, turn the cap to the right until you hear a
click. This signals that the fuel cap is fully seated. A built‑in device
prevents overtightening.
• The fuel tank has a manual vent screw which should be closed for
transportation and open for operation and cap removal.
Since sealed fuel tanks are not vented, they will expand and contract as the
fuel expands and contracts during heating and cooling cycles of the outside air.
This is normal.
REMOVING THE FUEL CAP
a - Fuel cap
b - Manual vent screw
c - Tab lock
IMPORTANT: Contents may be under pressure. Rotate the fuel cap 1/4 turn to
relieve pressure before opening.
1. Open the manual vent screw on top of the fuel cap.
2. Turn the fuel cap until it contacts the tab lock.
3. Press down on the tab lock. Rotate the fuel cap 1/4 turn to relieve the
pressure.
4. Press down on the tab lock again and remove the cap.
DIRECTIONS FOR USING THE PRESSURIZED PORTABLE FUEL TANK
1. When installing the fuel tank cap, turn the cap to the right until you hear a
click. This signals that the fuel cap is fully seated. A built‑in device
prevents overtightening.
2. Open the manual vent screw on top of the cap for operation and cap
removal. Close the manual vent screw for transportation.
3. For fuel hoses that have quick disconnects, disconnect the fuel line from
the engine or fuel tank when not in use.
4.
Follow Filling Fuel Tank instructions for fueling.
a
b
c
46290
FUEL AND OIL
50 eng