Product Manual

!
WARNING
Trimming the outboard beyond a neutral steering condition may result in a
pull on the steering wheel or tiller handle and loss of boat control. Maintain
control of the boat if trimming beyond a neutral steering condition.
Consider the following lists carefully.
1. Trimming in or down can:
• Lower the bow.
• Result in quicker planing off, especially with a heavy load or a stern
heavy boat.
• Generally improve the ride in choppy water.
• Increase steering torque or pull to the right (with the normal right‑hand
rotation propeller).
• In excess, can lower the bow of some boats to a point where they
begin to plow with their bow in the water while on plane. This can
result in an unexpected turn in either direction (called bow steering or
oversteering) if any turn is attempted, or if a significant wave is
encountered.
!
WARNING
Operating the boat at high speeds with the outboard trimmed too far under
can create excessive bow steer, resulting in the operator losing control of
the boat. Install the trim limit pin in a position that prevents excessive trim
under and operate the boat in a safe manner.
• In rare circumstances, the owner may decide to limit the trim in. This
can be accomplished by repositioning the tilt stop pin into whatever
adjustment hole in the transom bracket is desired.
2. Trimming out or up can:
• Lift the bow higher out of the water.
• Generally increase top speed.
• Increase clearance over submerged objects or a shallow bottom.
• Increase steering torque or pull to the left at a normal installation
height (with the normal right‑hand rotation propeller).
• In excess, can cause boat porpoising (bouncing) or propeller
ventilation.
• Cause engine overheating if any cooling water intake holes are above
the waterline.
TILTING OPERATION
To tilt the outboard, shut off the engine and press the trim/tilt switch or auxiliary
tilt switch to the up position. The outboard will tilt up until the switch is released
or it reaches its maximum tilt position.
FEATURES AND CONTROLS
68 eng