Product Manual
Table Of Contents
- 25/30 EFI FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Outboard Remote Control Models
- Exhaust Emissions
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- High-Speed and High-Performance Boat Operation
- Impact with Underwater Hazards
- Safety Instructions for Hand-Tilled Outboards
- Safe Boating Recommendations
- Conditions Affecting Performance
- Recording Serial Number
- Model Year Production Code
- Component Identification
- Specifications
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Cleaning Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Top Cowl Removal and Installation
- Cooling System
- Corrosion Control Anode
- Engine Oil
- Fuel System
- Gearcase Lubrication
- Lubrication Points
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
AUXILIARY TILT SWITCH
The auxiliary tilt switch can be used to tilt the outboard up or down using the
power trim system.
74338
SHALLOW WATER OPERATION
When operating your boat in shallow water, you can tilt the outboard beyond
the maximum trim range to prevent hitting bottom.
1. Reduce the engine speed below 2000 RPM.
2. Tilt the outboard up. Make sure all the water intake holes stay submerged
at all times.
3. Operate the engine at slow speed only.
Warning System
WARNING HORN
Remote control models will have the warning horn located inside the remote
control or connected to the ignition key switch.
Tiller handle models will have the warning horn located in the engine cowl.
WARNING SYSTEM OPERATION
The warning horn will emit either a continuous beep or intermittent short beeps
and engine speed will be limited. This will alert the operator and help identify
the following listed situations.
Function
Warning Horn Description Rev Limit
Start up One beep Normal system test n/a
Engine overheat Continuous Engine overheat 2800 RPM
Low oil pressure Continuous Low oil pressure 2800 RPM
Engine overspeed Continuous
Engine speed exceeds
maximum allowable RPM
n/a
FEATURES AND CONTROLS
70 eng