Assembly Instruction

2of2
(Step 3 Continued)
D. Remove the Canopy Lock
Ring (FF) and the Ceiling
Canopy (HH). Tighten the
Hex Nut (CC) against the
Crossbar (AA) to secure in
place.
Figure 3
AA
BB
CC
Step B
Step A
DD
CC
BB
EE
FF
HH
STEP 4 - Install the Fixture Chain and Ceiling Canopy
A. Pull the supply wires and ground wire through the Canopy Lock
Ring (FF) and the Ceiling Canopy (HH) in order.
B. Connect the Fixture Loop (A) to the Canopy Chain Loop (EE) by
using the Quick Link (GG). The fixture will now hang safely.
C. Feed the Supply Wires and Ground Wire through the Canopy Chain
DD
Supply
Wires and
Ground Wire
EE
A
FF
GG
HH
Loop (EE) and Nipple (DD)
into the Outlet Box. Cut the
wires leaving approximately 8”
of wire extending from the
Outlet Box.
D. Go to Step 5 for wire
connections and follow the
directions. Return to Step E in
this step when complete with
Step 5.
E. Raise the Ceiling Canopy (HH)
and Canopy Lock Ring (FF) up
the Quick Link (GG) and over
the Canopy Chain Loop (EE).
Tighten the Canopy Lock Ring
(FF) onto the Canopy Chain
Loop (EE) until tight.
Figure 4
Figure 5
STEP 5 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire from fixture
identified with the Label “N”
Black wire from
outlet box (or Red)
Black wire from fixture
identified with the label “L”
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
(Step 5 Continued)
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
STEP 6 - Install Bulbs and Glass Shades
A. Insert bulbs onto sockets and screw snugly into place.
B. Place Glass Shades (E) over bulbs onto bobeches.
Your fixture is now assembled and ready to use. Enjoy!
Socket
Bulb (not
supplied)
E
Figure 6
FINISH: EARTH BLACK
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
54” OVERALL
HEIGHT INCLUDES
SINGLE CHAIN,
QUICK LINK,
(2) 6” RODS AND
(2) 12” RODS
28” Dia.
19.5”
5” Dia.
2.5” Dia.
6”
Bobeche
Thank you for purchasing product.
Need assistance with parts or assembly? Call customer service