Specifications

Erasing personal codes

1. Enter the factory set 5–digit code. The keyless entry keypad and

interior lights will illuminate and the driver’s door will unlock.

2. Press and release the 1 • 2 within five seconds of completing Step 1.

3. Press and hold the 1 • 2 for two seconds to erase the customer

programmed codes.

All personal codes are now erased and only the factory set 5–digit code

will work.

Note: To exit programming mode, either wait 5 seconds after pressing 1

• 2 on the keypad, or press the 7 • 8 and 9 • 0 pads simultaneously to

lock all vehicle doors and end programming mode.

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your

personal code. Each number must be pressed within five seconds of each

other. The interior lamps will illuminate.

To unlock all doors and the liftgate (wagon), enter the factory set code

or your personal code, then press the 3 • 4 control within five seconds.

To unlock the trunk or unlock the liftgate (wagon), enter the

factory set code or your personal code, then press the 5 • 6 control

within five seconds.

To lock all doors, press the 7 • 8 and the 9 • 0 at the same time. You

do not need to enter the keypad code first.

Autolock (if equipped)

This feature automatically locks all vehicle doors when the following

conditions are met:

• all the doors are closed,

• the engine is running,

• you shift into gear, putting the vehicle in motion, and.

• the vehicle’s speed is greater than 3 mph (5 km/h).

Relock

The autolock feature repeats when the following conditions are met:

• any door is opened then closed while the engine is running, and

• you shift into gear, putting the vehicle in motion, and

• the vehicle’s speed is greater than 3 mph (5 km/h).

REVIEW COPY

2005 Sable (sab), Owners Guide (post-2002-fmt) (own2002),

Market: USA_English (fus)

Locks and Security