Installation Instructions

19
20
INSTALLATION GUIDE
DETAIL 
Valley
1. Install underlayment in valley sesction of roof using woven format or bleeder strip
application. (Refer to local building codes)
2. Position 906 Valley at the eave and cut flush with 902 Starter.
3. Fasten 906 Valley using #12 x 1 ½” screws or nails 12” OC through the outer channel
near the hem on both sides of the valley.
4. Overlap pieces 6”.
NOTES
Underlayment
Roof Deck
Flush at eave
(cut valley to fit shape
of eave. See previous
detail for same step)
DETAIL 
Side-wall flashing
1. Install underlayment and turn 4” up the side wall
2. Fasten 708 Universal Flashing flush with 902 Starter prior to exterior cladding being installed.
3. At the eave, position universal channel flush with fascia.
4. Fasten 708 Universal flashing with #12 x 1 ½ screws 12” OC in the outer pan nearest the hem.
5. Kick out required (refer to local building codes).
1. Flush with 902 Starter.
2. Fasten 708 Universal flashing with #12 x 1 ½” screws 12” OC in the outer pan nearest the hem.
3. Overlap 6”.
4. If no wall flashing is present, install 705 USA side flashing using proper sealant and fasteners.
5. Kick out required (refer to local building codes).
NOTES
New Construction
Reroof
715 Side Flashing
FIG. 04.A
FIG. 05.A
708 Universal Flashing
Side-wall
902 Starter
#906 Valley