Operation Manual

INSTALLING THE

CD PLAYER

Do not, under

any circumstances, connect any

equipment other than Meridian G Series, 500

Series, or 800 Series to any socket marked

COMMS on the back of the product.

The following automatic setup procedure should be used to set up the

Comms correctly between several products:

• Connect one of the DIN COMMS sockets on the back panel of the CD

player to one of the COMMS sockets on another G Series, 500 Series, or

800 Series unit, using the Comms leads provided with the products.

The sequence in which you connect the units is not important.

• Switch all the units to standby.

• Press Clear (remote).

Each unit will display:

Auto

One unit will then be designated

as the controller, and display:

Controller

All the other units will be conﬁ gured

as non-controllers, and display:

Not Con.

If for any reason the automatic setup does not work, make sure you are

operating the remote from a position where all the units can receive the

infra-red, and try again.

If this fails:

• Restore the default operation by selecting one of the standard types; see

Choosing a standard setting, page 30.