User guide

30
Setting up the 810
System
Stage 2: Projector settings
The Configuration Wizard provides access to the
essential projector settings, needed to obtain a visible
on-screen display.
Once these settings have been configured correctly,
further settings can be adjusted using the remote
control and on-screen display, as described in Adjusting
the projector, page 36.
To configure the projector settings
Either:
Press Skip after resetting the product; see Stage 1:
Resetting the product , page 29.
Or:
Press Wizard; see Configuration Wizard , page 28.
Press Skip to skip past the Reset settings menu.
The display shows the title screen for stage 2:
%NTER 3KIP"ACK
0ROJSETTINGS
Press Enter to proceed or Skip to go to stage 3.
The display shows the first projector setting, Test
Pattern, and the current value of that setting, Off:
z{|wxy"ACK .EXT
4EST0ATTERN
3ET
/FF
Press Next or Back to step between settings.
The options are summarised in the table on the next
page.
To change a setting
Press A or V to step through the alternative values
for the setting.
•
•
•
•
•
•
To move to the next setting
Press Source.
When you have finished configuring projector settings:
Either:
Press Next on the last option of the last source
(Force Signal) to proceed to configuring settings, as
described in the next section.
Or:
Press Power to return to standby.
•
•
•