User guide

iv
Preface
registers, stoves, and other products (including
amplifiers) that produce heat.
When connecting other products such as VCRs, and
DVD players, you should turn off the power of this
product for protection against electric shock.
Do not place combustibles behind the cooling fan.
For example, cloth, paper, matches, aerosol cans or
gas lighters that present special hazards when over
heated.
Do not look into the projection lens while the
illumination lamp is turned on. Exposure of your eyes
to the strong light can result in impaired eyesight.
Do not look into the inside of this unit through
vents (ventilation holes), etc. Do not look at the
illumination lamp directly by opening the cabinet while
the illumination lamp is turned on. The illumination
lamp also contains ultraviolet rays and the light is so
powerful that your eyesight can be impaired.
Do not drop, hit, or damage the light-source lamp
(lamp unit) in any way. It may cause the light-source
lamp to break and lead to injuries. Do not use a
damaged light source lamp. If the light-source lamp
is broken, ask your retailer to repair it. Fragments
from a broken light-source lamp may cause injuries.
The light-source lamp used in this projector is a
high pressure lamp. Be careful when disposing of
the lightsource lamp. If anything is unclear, please
consult your retailer.
Do not ceiling-mount the projector to a place which
tends to vibrate; otherwise, the attaching fixture
of the projector could be broken by the vibration,
possibly causing it to fall or overturn, which could
lead to personal injury.
Use only the accessory cord designed for this
product to prevent shock.
*DO NOT allow any unqualified person to install the unit.
Be sure to ask your retailer to install the unit (eg
attaching it to the ceiling) since special technical
knowledge and skills are required for installation. If
installation is performed by an unqualified person, it
•
•
•
•
•
•
•
•
may cause personal injury or electrical shock.
Power connection
The power supply voltage rating of this product is AC
110V – 120 V, AC 200V – 240V. The power cord
used must conform to the power supply voltage. Use
only the power cord designated by your retailer to
ensure Safety and EMC. Ensure that the power cable
used for the projector is the correct type for the AC
outlet in your country. Consult your Meridian retailer for
more details.
WARNING: Do not cut off the main plug from this
equipment. If the plug fitted is not suitable for the
power points in your home or the cable is too short
to reach a power point, then obtain an appropriate
safety approved extension lead or adapter or consult
your retailer. If nonetheless the mains plug is cut off,
dispose of the plug immediately, to avoid a possible
shock hazard by inadvertent connection to the main
supply. If a new main plug has to be fitted, then follow
the instruction given below.
WARNING: THIS APPARATUS MUST BE EARTHED.
IMPORTANT:
The wires in the mains lead on this product are
coloured in accordance with the following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As these colours may not correspond with the colored
marking identifying the terminals in your plug, proceed
as follows: The wire which is coloured green-and-yellow
must be connected to the terminal which is marked
with the letter E or the safety earth or coloured green
or green-and-yellow. The wire which is coloured blue
must be connected to the terminal which is marked
with the letter N or coloured black. The wire which
is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.