User guide

Maintenance

Procedure

1. Remove the filter cover and filter panel

The filter is located at the front and side of the

projector unit.

2. Remove the sponge, filter, and honeycomb

Hold the centre of the filter using your fingers, and pull

the filter toward you to remove it.

3. Clean the sponge, filter, and honeycomb

Remove any dirt or dust using a vacuum cleaner.

CAUTION: Do not clean using a flammable air duster.

This may cause fire.

4. Mount the sponge, filter, and honeycomb

Mount the filter to the projector using the reverse of the

removal procedure.

Finally, check to ensure that the filter cover and filter

panel are firmly mounted.

NOTE: Mount the filter correctly. Failure to do so may

cause the projector to malfunction.

The projector may stop operating if a damaged filter

or filter panel is used. In this case, replace the filter or

filter panel with a new one.